10/21/2023 0 Comments How to chop and section a car![]() You want at least 1 to 2 inches of clean metal surrounding the cut out areas and then spray the raw metal with the rust treatment spray. ![]() ![]() ![]() Grind the cut out edges smooth with your grinder and clean the edges of the metal surrounding your cut out section with your wire brush, rust scuffer pad or sandpaper. Rims are some 14" fujimi "shadow spoke wheels". Survey the area behind your cut to be sure you wont be damaging another area of the car. It can’t be assumed that the trunk-latch mechanism is in the middle of the car. Assuming the body is unwrinkled and the rear quarter panels are straight, a tape is used to measure across the back of the car to find the exact center of the rear area. ![]() Well the kist is the revell tuner series datsun 510 that i chopped the top on by a couple of mm, and i decided to go all out with this one, making my first roll cage that was scratch built, and i decided to throw a flathead V8 in it, just because i wanted it to be different and i had the engine lying around. section of the rails, is transferred to the frame rails themselves, which are then cut to length. Well here she is, finally finished after about a year, well actually 99% complete, as i still need to cut the windows to size:uhoh: (tips for this would be appreciated).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |